Brad asks for a little help setting sag on WR250R WR250X lowering link YamaLink

Brad, The YamaLink comes with super easy to follow install instructions. Here is a copy/paste of the fine tuning:

RESET SAG to factory spec. Most settle at 3.25 inches. If you feel the rear is too soft, turn in the compression just a little bit & rebound in 1 or 2 clicks. Fine-tune based on terrain, personal preference, etc. Combined with the stock .9 inch lowering option via the shock block (http://www.wrrdualsport.com/tech-guide/suspension/115-lowering-r2), the YamaLink lowers the rear suspension an additional inch.

IMPORTANT! Slide the fork tubes UP in the triple clamps - start at around 12mm & adjust based on preference. FYI, 18mm is the MAX you should go. Re-torque the upper fork clamp bolts to 17ft. lbs. & the lower clamp bolts to 14ft. lbs. And don't forget to properly tighten the chain before riding.