UK rider Simon had a question about the fit and install of his WR250F:
Firstly I would thank you for the quick delivery of this item however, I not sure if either I have ordered the wrong item or the wrong item has been shipped as it does not fit my model of bike, neither does it match the picture on the web site. The width of the link is narrower then the stock item or it is missing inner bushes as the diameter or the link bolts is significantly narrower than those on the link . I have not fitted obviously and just wondered if I was missing something as the installation video shows this as a straight replacement. The one received just had needle rollers with dust cover either side. there are no spacer bushes slid into the bearings.
Please Advise
And our reply.....
The typed installation directions call for you to put your finger in the stock Yamaha rocker and pop out the two bearing pins and 4 bushings. This procedure take about 3 seconds and only requires 1 finger. Any finger. I'll copy/paste:
2. Pick up the stock rocker. Stick a finger in the 2 main pivots & pull out the metal bushings & pivot pins. Insert into the YamaLink. Be careful no needle bearings pop out. Everything should “snap” straight into place.
The directions also call for you to insert those parts into the YamaLink before installation. The picture on our website is for a pre-2005 Yamaha.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment